The first Instrument – Altimeter
Another thing on my todo list for the sim are fully working analogue instruments. (more…)
New Throttlemount – finally finished
My 3D printed mount for the throttle was too weak – so I had to start again… (more…)
New Throttlemount
Until now the throttle has been mounted to a piece of wood which made the whole thing quite flimsy.
The flightsim is starting again!
Due to FS2020 and DCS World I got hooked to flightsimming again and want to reactivate my cockpit to full operational status. (more…)
DIY USB Wheel 03
Phase 3 – Building
After everything has been planned at the prototype looked like I intended it to I started with the final build. (more…)
(c)mhirczy
Racingrig 10 – Triple monitors
Since the last simrig update I upgraded to a triplemonitor setup + addon monitor. (more…)
DIY USB Wheel 02
After finishing most of the design work I started with programming the firmware and building a first prototype out of Plywood.
DIY USB Wheel 01
For quite some time I wanted to build a complete GT3-style steering wheel which could be used on any wheelbase. (more…)
Racingrig 09 Status 01-2021
I made quite a lot of modification on the racing seem last year, but didn’t document everything properly – I like racing in it too much :D.
Now it’s time to describe all the changes I’ve done.
DIY Buttonplate for the Fanatec UniversalHub
For quite some time I have been driving with my Fanatec CSL Elite and the default wheel. But I wanted to have a bit more racing like wheel and I found a nice Sparco P104 Limite clone. (more…)
