DIY Dzus Fasteners
At last the panels can be mounted 🙂 (more…)
At last the panels can be mounted 🙂 (more…)
The consoles are going to be reworked. (more…)
Work on the Aoa indicator has begun. (more…)
After about 2 months of building the altimeter has been finally finished! (more…)
Just the baro settings display and connector plate are still missing, everything else is working fully inside the instrument. (more…)
Another thing on my todo list for the sim are fully working analogue instruments. (more…)
My 3D printed mount for the throttle was too weak – so I had to start again… (more…)
Until now the throttle has been mounted to a piece of wood which made the whole thing quite flimsy.
Due to FS2020 and DCS World I got hooked to flightsimming again and want to reactivate my cockpit to full operational status. (more…)
After everything has been planned at the prototype looked like I intended it to I started with the final build. (more…)
Since the last simrig update I upgraded to a triplemonitor setup + addon monitor. (more…)
After finishing most of the design work I started with programming the firmware and building a first prototype out of Plywood.
For quite some time I wanted to build a complete GT3-style steering wheel which could be used on any wheelbase. (more…)