Finally – the altimeter is done
After about 2 months of building the altimeter has been finally finished! (more…)
The Altimeter is (nearly) finished
Just the baro settings display and connector plate are still missing, everything else is working fully inside the instrument. (more…)
The first Instrument – Altimeter
Another thing on my todo list for the sim are fully working analogue instruments. (more…)
New Throttlemount – finally finished
My 3D printed mount for the throttle was too weak – so I had to start again… (more…)
New Throttlemount
Until now the throttle has been mounted to a piece of wood which made the whole thing quite flimsy.
The flightsim is starting again!
Due to FS2020 and DCS World I got hooked to flightsimming again and want to reactivate my cockpit to full operational status. (more…)
DIY USB Wheel 03
Phase 3 – Building
After everything has been planned at the prototype looked like I intended it to I started with the final build. (more…)
Racingrig 10 – Triple monitors
Since the last simrig update I upgraded to a triplemonitor setup + addon monitor. (more…)
DIY USB Wheel 02
After finishing most of the design work I started with programming the firmware and building a first prototype out of Plywood.
DIY USB Wheel 01
For quite some time I wanted to build a complete GT3-style steering wheel which could be used on any wheelbase. (more…)
Racingrig 09 Status 01-2021
I made quite a lot of modification on the racing seem last year, but didn’t document everything properly – I like racing in it too much :D.
Now it’s time to describe all the changes I’ve done.
DIY Buttonplate for the Fanatec UniversalHub
For quite some time I have been driving with my Fanatec CSL Elite and the default wheel. But I wanted to have a bit more racing like wheel and I found a nice Sparco P104 Limite clone. (more…)
