New Throttlemount – finally finished
My 3D printed mount for the throttle was too weak – so I had to start again… (more…)
0 Comments
2022-09-10
New Throttlemount
Until now the throttle has been mounted to a piece of wood which made the whole thing quite flimsy.
2022-08-19
The flightsim is starting again!
Due to FS2020 and DCS World I got hooked to flightsimming again and want to reactivate my cockpit to full operational status. (more…)
2022-08-05
DIY USB Wheel 04
2022-05-29
DIY USB Wheel 03
Phase 3 – Building
After everything has been planned at the prototype looked like I intended it to I started with the final build. (more…)
2022-05-06
(c)mhirczy
Racingrig 10 – Triple monitors
Since the last simrig update I upgraded to a triplemonitor setup + addon monitor. (more…)
2022-03-25
DIY USB Wheel 02
After finishing most of the design work I started with programming the firmware and building a first prototype out of Plywood.
2021-03-30
DIY USB Wheel 01
For quite some time I wanted to build a complete GT3-style steering wheel which could be used on any wheelbase. (more…)
2021-03-18